Welcome to Honda CX500 & GL500 Forum Sign in | Join | Faq

Technical Help Forum

Started by Landini2&4stroke at 07-20-2010 6:31 AM. Topic has 6 replies.

Print
Sort Posts:    
   07-20-2010, 6:31 AM
Landini2&4stroke is not online. Last active: 7/22/2010 10:31:51 PM Landini2&4stroke

Not Ranked
Joined on 06-28-2010
St. Catharines Ontario
Posts 13
now my cx500 standard quits running on right cylinder at idle only when hot
Reply Quote
I cant seem to get past this problem. It's really wearing on me and if seen threads with similar symptoms but no solid answer. I don't know if this is related but i notice the Bike runs great when cold and for maybe 10-20mins then the tach needle waves back and forth when i ease off the throttle to cruise. Feels like fuel starvation. Im lost on this one.
1979 CX500 Standard USA version

   Report 
   07-21-2010, 1:39 AM
vern401 is not online. Last active: 7/21/2010 8:25:10 AM vern401



Top 200 Posts
Joined on 05-23-2010
Vass, NC
Posts 197
Re: now my cx500 standard quits running on right cylinder at idle only when hot
Reply Quote
It could be in the carbs ... It sounds allot like a coil or igniter starting to fail to me.

I would use a spair plug and check the spark on that side cold and then again when it is hot. see if there is a difference in spark color etc.
79 CX500 Custom
72 SL350 K2
78 CB750F
91 Kawasaki ZX600C4
   Report 
   07-21-2010, 6:00 AM
gwynethh is not online. Last active: 7/22/2010 12:09:49 AM gwynethh



Top 500 Posts
Joined on 04-05-2009
Kittery, ME
Posts 138
Re: now my cx500 standard quits running on right cylinder at idle only when hot
Reply Quote
Check the condition of your spark plug boots. One of mine is electrically breaking down and will allow arcing to the side wall of the valve cover. It seems more prevalent after warm up. The rubber water seal cap may also be allowing in rain water that vaporizes when the bike is warm thus causing a trapped high humidity area that will encourage the discharge via a weak insulation area in the boot.

Try pulling the boot and drying the sleeve and boot. If you find moisture maybe apply some dielectric grease to the boot to see if that helps also.

Party On Dudes and Dudettes
1989 PC800 "Silver Lady"
1982 GL500I "Jenny"
   Report 
   07-21-2010, 3:24 PM
Landini2&4stroke is not online. Last active: 7/22/2010 10:31:51 PM Landini2&4stroke

Not Ranked
Joined on 06-28-2010
St. Catharines Ontario
Posts 13
Re: now my cx500 standard quits running on right cylinder at idle only when hot
Reply Quote
I switched the boots and caps from side to side and the problem remains the same.
UPDATE:
-cleaned re gapped plugs.
-played with mixture screw.

Problem: Misses on acceleration. And Im almost positive its the right side acting up.

Next im gonna check the float bowl for crud.
1979 CX500 Standard USA version

   Report 
   07-21-2010, 3:42 PM
Shep is online. Last active: 7/25/2010 2:40:38 AM Shep



Top 10 Posts
Joined on 01-30-2007
UK.2x1980CX500A
Posts 7,647
Re: now my cx500 standard quits running on right cylinder at idle only when hot
Reply Quote
Incorrect float height will cause this,

http://globalcxglvtwins.hostingdelivered.com/viewtopic.php?f=19&t=110

As would a coil breaking down under heat.


My Music

http://www.reverbnation.com/pauldouglas/

Join Just In Case :)
http://globalcxglvtwins.hostingdelivered.com/

Id quot circumiret, circumveniat

   Report 
   07-21-2010, 7:12 PM
Landini2&4stroke is not online. Last active: 7/22/2010 10:31:51 PM Landini2&4stroke

Not Ranked
Joined on 06-28-2010
St. Catharines Ontario
Posts 13
Re: now my cx500 standard quits running on right cylinder at idle only when hot
Reply Quote
Nice one Shep.
It was a coil. Just like that.

I did lower the float height on that right cylinder before i found out it was the coil. Only because the I thought the plug was fouling. I've had nothing but fuel problems for the last 2 weeks that i'm just now getting over the fact that its not fuel, so i don't have to clean the carbs for the 5th time.

Tomorrow I takle the Starter clutch springs and rollers, with torx bolts and cherry red loctite. And while i'm in her for the second time this year (stator) I wanted to replace the Mech-Seal.

I may have a brand new second hand coil by saturday. Anyone here from the Niagara Region of Ontario? and with a Coil.
I really like these bikes. Almost as much fun to work on as my '72 Yamaha 200twin


1979 CX500 Standard USA version

   Report 
   07-22-2010, 12:38 AM
Shep is online. Last active: 7/25/2010 2:40:38 AM Shep



Top 10 Posts
Joined on 01-30-2007
UK.2x1980CX500A
Posts 7,647
Re: now my cx500 standard quits running on right cylinder at idle only when hot
Reply Quote
See this thread,

http://globalcxglvtwins.hostingdelivered.com/viewtopic.php?f=10&t=335

These work,

http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&item=280447779459&ssPageName=STRK:MEWNX:IT

but are only for the CDI ignition bikes,NOT the transistor ignition bikes.
My Music

http://www.reverbnation.com/pauldouglas/

Join Just In Case :)
http://globalcxglvtwins.hostingdelivered.com/

Id quot circumiret, circumveniat

   Report 
Honda CX500 & G... » CX500 GL500 Tra... » Technical Help ... » now my cx500 standard quits running on right cylinder at idle only when hot

Powered by Community Server, by Telligent Systems